Skip to content
|EVC
Back to Spare Parts

KA-01527

Energymeter Eve Single Plus

Energymeter

Energymeter Eve Single Plus

Only for professional use by qualified personnel and professionals. For sale and delivery of Spare Part kits, the Alfen general terms and conditions of sale (the ‘General Terms’) and the Alfen Carry-in Warranty (the ‘”Warranty”) applies, which can be downloaded here: Terms & Conditions repair and/or maintenance of the Alfen Product(s) by an unauthorized party may result in loss of warranty.

SPK Energymeter Eve Single Plus 803874121


EU and FR variant only! This instruction is not applicable for the DE version of the Eve Single Plus.

Contents of the kit

Part numberDescriptionQuantity in the kit
104002112-ICUkWh Reallin D3132-AA1

Step-by-step summarized instruction for "SPK EnergyMeter Eve Single Plus"

  1. Open the front housing housing by removing the 6x Torx 20 screws

  2. Unplug the Hybrid Connector from the Socket to the SB100

    1. Press both ledges to unlock while pulling the connector up

  3. Lift the “Subframe” after removing the 3x Torx 20 screws

  4. Unplug the RS485 connector from the energy meter by pulling it upwards (no ledge)

  5. Remove the power cables from the energy meter by opening the 8x Slotted Pozidriv 2 screws

    1. Ensure you memorize or photograph the cable order (left to right: blue, grey, black, brown)

  6. Release the energy meter from the DIN rail by pulling the click nose up with a flathead screwdriver

    1. Notice that the energy meter is place upside down in the charger

  7. Isolate the old (defective) “energy meter” and grab the replacement “energy meter”

  8. Place the replacement “energy meter” in the charger on the DIN rail until the click nose is locked

    1. Notice that the energy meter must be placed upside down in the charger

  9. Plug the power cables back in the energy meter and fasten the 8x Slotted Pozidriv 2 screws (torque: 1.5Nm)

    1. Ensure that the power cables are in the correct order (left to right: blue, grey, black, brown)

  10. Place the RS485 connector back in the energy meter (poka yoke)

    1. The RS485 connector should be placed in deep enough until the (black) connector is flush with the protrusion of the energy meter housing and can’t be seen sticking out

  11. Place the “Subframe” back in the charger and fix with the 3x Torx 20 screws (torque: 1Nm)

  12. Route the cable from the socket around the outside of the “Subframe” and plug the Hybrid Connector in the SB100

    1. Ensure the connector is correctly placed, both ledges should be locked

  13. Close the front housing and fix with the 6x Torx 20 screws (torque: 1Nm)

Was this article helpful?