T2S socket Eve Single Plus

Only for professional use by qualified personnel and professionals. For sale and delivery of Spare Part kits, the Alfen general terms and conditions of sale (the ‘General Terms’) and the Alfen Carry-in Warranty (the ‘”Warranty”) applies, which can be downloaded here: Terms & Conditions repair and/or maintenance of the Alfen Product(s) by an unauthorized party may result in loss of warranty.

SPK T2S socket Eve Single Plus 803874119

FR variant only! This instruction is not applicable for the DE and EU products.

Contents of the kit

Step-by-step summarized instruction for "SPK T2S socket Eve Single Plus"

1. Open the front housing housing by removing the 6x Torx 20 screws

2. Unplug the Hybrid Connector from the Socket to the SB100

   1. Press both ledges to unlock while pulling the connector up

3. Lift the “Subframe” after removing the 3x Torx 20 screws

4. Separate the “T2S Socket” from the “Subframe” by removing the 4x Torx 20 screws

5. Isolate the old (defective) “T2S socket” and grab the replacement “T2S Socket”

6. Assemble the replacement “T2 socket” on the “Subframe” and fix with the

   4x Torx 20 screws (torque: 0.6Nm)

7. Place the “Subframe” back in the charger and fix with the 3x Torx 20 screws (torque: 1Nm)

8. Route the cable from the socket around the outside of the “Subframe” and plug the Hybrid Connector in the SB100

   1. Ensure the connector is correctly placed, both ledges should be locked

9. Close the front housing and fix with the 6x Torx 20 screws (torque: 1Nm)